
Keep people away from a sagging ceiling or wet electrical equipment
If the ceiling is visibly bowed, water is near a light or outlet, or the source is uncertain, stop using the affected space and get appropriate help. Take photos only from a safe position. Tell the contractor if the leak is ongoing, what was above the damaged area and when it appeared.
Find and stop the water entry
Start with the outside source if the stain correlates with rain. Water can travel before it shows up inside, so the roofer may need to inspect a nearby wall, chimney or penetration as well as the roof directly over the stain. IKO's roof leak guide describes why the source and ceiling drip can be apart. If the timing points toward a plumbing fixture or condensation, tell the contractor early so the right trade can investigate.
Dry the materials and assess the cavity
The EPA's homeowner guide advises drying water-damaged areas and items within 24 to 48 hours to help prevent mold growth. Start arranging drying promptly while the source is being addressed. Ask a qualified professional to evaluate the area if water damage is widespread, moisture is concealed or mold is suspected.
For clean-water incidents, the EPA moisture response table says wallboard may sometimes be dried in place when there is no obvious swelling and its seams are intact. A swollen board or damaged seam calls for a different assessment. Ask about the insulation and framing behind the surface, too. A dry coat of paint provides little information about those materials.
Write down who handles each handoff
| Step | What to ask for |
|---|---|
| Exterior repair | What failed, what was fixed and which areas still need inspection? |
| Drying and assessment | Who checks the drywall, cavity and insulation, and how will they determine when the area is ready? |
| Interior finish | What will be removed or patched, and does the scope include texture, primer and paint? |
For an illustrative handoff, a roofer traces the entry to a roof transition and repairs it. A drying specialist inspects the wet insulation. The drywall contractor then estimates replacement board, seam finishing and matching texture after the cavity is ready. One company may coordinate steps or you may hire multiple trades directly.
Describe the roof symptom on the roof repair page and ask which parts of the drywall repair scope can be quoted together. Include when the moisture was last seen and what work has already been done.
